Poseable Parts?

[AkiraParticipant]

I’m very new at sewing (just really started learning earlier this year) but there has been a project I’ve had on my mind for a while but I’ve wanted to add poseable wired parts to it. Is there any recommended way to do this? It well not be a large section of the work but I’d like to avoid using hot glue for as much as I can. Any advice would be greatly appreciated!

[professorpincushionParticipant]

sorry, are you asking how to attach a poseable part to something with sewing instead of hot glue? If the end of it has exposed poseable wire, you can attach a small ring of some kind, like a grommet and then stitch through the grommet onto the other part of the project. I’m just not sure if it’s going to have enough stability to do everything, like if you want the poseable part to stand straight up, it might instead flop over. But that would be the easiest way to get it attached.

[AkiraParticipant]

This would work I’m sure! I didn’t want it to be too strong anyway so I’ll give it my best shot, thank you so much!

[Author]

Posts