Book Promo Banner
Simplicity Pattern 2172- Trimmed Seam Allowance Mistake

Simplicity Pattern 2172- Trimmed Seam Allowance Mistake

Home Page › Forums › Ask A Question › Simplicity Pattern 2172- Trimmed Seam Allowance Mistake

Tagged: ,

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 8, 2018 at 11:57 AM #70766
    Donna Farris
    Participant

      I hope you can help. I have been following your tutorial video on Simplicity’s pattern 2172. Working on the skirt: I managed to get the body of the skirt and pleats done. I was in the process of adding the waist band to the gathered portion of the skirt. I don’t know how it happened but when I went to trim my seam allowance, My pecking sears clipped more than just the allowance. I think I know how to correct it, but I would like to have some adult supervisor advice on the process.

      Sincerely
      D

      May 8, 2018 at 11:59 AM #70767
      Donna Farris
      Participant

        Ps. I am thinking that I am going to have to remove the entire waist band (via cutting) – move the zipper placement down 1//4-1/2 inch and start over. ?? Would this be correct??

        D

        May 9, 2018 at 1:57 PM #70789
        professorpincushion
        Participant

          If it’s just a slice, and not an actual hole, maybe put some lightweight interfacing fused to the inside to hold it together and reinforce the area. If it were me, I’d rather try to do a simple repair then take out the whole waistband.

          May 10, 2018 at 11:00 AM #70804
          Donna Farris
          Participant

            Thanks!! However, the cut was a little bit bigger than I thought . It’s on the inside and won’t be “seen” however I tend to be somewhat of a perfectionist at times. I will try the patch before I “take out” the band. Again thanks!!

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • The forum ‘Ask A Question’ is closed to new topics and replies.